rotor process

This paper describes technology process of stator frame and rotor spider for Wuq iangxi power station.

本文对五强溪机组的主要焊接部件定子机座和转子支架的制造工艺进行了论述,仅供参考.

This paper did a simulation research on the loading process of hydraulic dynamometry rotor.

对水力测功器转子的承载过程进行了仿真研究。

This paper describes technology process of stator frame and rotor spider for Ertan power station.

本文介绍了二滩机组的主要焊接部件定子机座和转子支架的制造工艺.

Study on Water Simulation of Spinning Rotor Process for Aluminium Alloys

铝合金旋转喷吹工艺的水模拟研究

Improvement and Application of Construction and Machining Process of Rotor Slot Wedges of YZR Range Wound-Rotor Motors

YZR系列电机绕线转子槽楔结构和加工工艺改进及应用

Domestic spinning rotor technology need to be exploited both in the sense of melt treatment process itself and comparing with overseas advanced degassing equipments was pointed out in the end.

最后指出无论从铝合金熔体处理本身的需要，还是与国外的先进除气设备相比，国内的旋转喷吹净化技术都有待开拓。

Abstract The paper introduces the situation of rotor spinning technology, the equipment level of homemade rotor spinner, the process lines of difference rotor yarns and the spinning range, economic count of vary rotor speed, and points out the products developing trend later in the paper.

介绍转杯纺纱现状、国产转林纺纱机设备水平，各种转杯纱所采用的不同工艺路线，以及不同纺杯转速下的适纺、经济号数，并提出产品方向。

Mechanism, parameters and advantages of a deburring process by heating are described, by which process burrs on silicon steel sheets and on the edge of Aluminium guide strips of the motor rotor are removed through heating.

本文介绍了一种脱壳去毛利工艺，即用加热法去除电机转子硅钢片和铝导条边缘毛刺工艺的机理、参数及优点。

The parametric method is used process of turbine rotor design and analysis in this paper.

本文引入了近年来结构设计中迅速发展的参数化思想,用于涡轮转子的结构设计与分析中.

And a low loading coefficient is more favorite for high-pressure rotor in the counter-rotating elementary stage designing process.

对转涡轮高压级基元设计应尽量选择较大载荷系数等观点和建议。